2 #@Name: Compulab cm-x270
3 #@DESCRIPTION: Machine configuration for Compulab cm-x270 computer module
4 #OLDEST_KERNEL = "2.6.16"
6 GUI_MACHINE_CLASS ?= "bigscreen"
8 PREFERRED_PROVIDER_virtual/kernel = "linux"
9 PREFERRED_VERSION_linux = "2.6.22"
11 PACKAGE_EXTRA_ARCHS = "armv4 armv5te"
13 require conf/machine/include/tune-xscale.inc
15 # console serial port. If you have a L module
16 # the below works. If you have a W module, add
17 # the following line to your local.conf:
18 # CMX270_CONSOLE_SERIAL_PORT = "ttyS0"
20 # the following is for the cm-x270 L module
21 CMX270_CONSOLE_SERIAL_PORT ?= "ttyS1"
23 # used by sysvinit_2 package, so rebuild this
24 # package if you change the SERIAL_CONSOLE setting
25 # the following is the port for the cm-x270 L module
26 # I think the W module would use ttyS0, but has
27 # not been tested. This can be overwritten in
29 SERIAL_CONSOLE ?= "38400 ${CMX270_CONSOLE_SERIAL_PORT}"
31 # used by opie-collections.inc
32 ROOT_FLASH_SIZE ?= "32"
35 EXTRA_IMAGECMD_jffs2 = "--little-endian --eraseblock=0x20000 --pad --no-cleanmarkers;\
36 sumtool -i ${DEPLOY_DIR_IMAGE}/${IMAGE_NAME}.rootfs.jffs2 \
37 -o ${DEPLOY_DIR_IMAGE}/${IMAGE_NAME}.rootfs-summary.jffs2 \
39 cd ${DEPLOY_DIR_IMAGE}; \
40 rm -f ${DEPLOY_DIR_IMAGE}/${IMAGE_LINK_NAME}.rootfs-summary.jffs2; \
41 ln -s ${IMAGE_NAME}.rootfs-summary.jffs2 ${IMAGE_LINK_NAME}.rootfs-summary.jffs2 \
44 MACHINE_FEATURES = "kernel26 pcmcia usbhost usbgadget pcmcia touchscreen alsa"
46 # to program the compulab NAND flash, the following scheme is suggested. Create
47 # a small rootfs that can fit in NOR flash using the following config:
49 # - uclibc (set ANGSTROM_MODE = "uclibc" in local.conf)
50 # - angstrom-minimal-image-with-mtd-utils bitbake target
51 # - put the following in your local.conf
52 # - IMAGE_FSTYPES = "jffs2 tar cpio.gz"
53 # now, when you build the image, a cpio.gz will be generated
54 # that can be used as an initramfs. You can boot into this image and then
55 # program the main rootfs jffs2 image in NAND flash using mtd-utils
56 # you can select booting the initramfs, or the main nand rootfs by using
57 # the "ramdisk on", or "ramdisk off" commands in the bootloader